APS NoChlor Floc Log

Applied Polymer Systems products harness the power of environmentally friendly materials to solve numerous water quality, erosion, and sediment challenges. Anionic polyacrylamide (PAM) is a polymer flocculant that can be used for a wide variety of erosion, sediment, and stormwater management applications. APS products bind, stabilize, and/or remove commonly problematic particles like sediment (clays, silt), metals, and nutrients to prevent erosion, clear water, and improve BMP performance. APS products are made and packaged in the United States, are drinking water quality (NSF/ANSI Standard 60 Certified), have been extensively toxicity tested by third party laboratories in accordance with EPA standards, and are safe for both terrestrial and aquatic organisms and environments.

Product Overview

APS NoChlor Floc Logs neutralize and decrease pH in flowing water using gentle materials. APS NoChlor Floc Logs are useful for construction, industrial, and municipal applications, or any water that requires economical, easy, and quick chlorine treatment.


Chlorine Treatment

Primary Applications

Removes Chlorine from:

  • Swimming Pools
  • Water Parks
  • Amusement Parks
  • Cruise Vessels
  • Municipalities

Features and Benefits

  • Removes Chlorine concentrations
  • Removes solubilized soils and clay from water
  • Allows dechlorinated water to be discharged into the open environment
  • No mechanical apparatus required, works with flowing water

Specifications / Compliances

Contains ANSI/NSF Standard 60 Drinking water treatment chemical additives


APS No Chlor Floc Logs are packaged 4/box.

Technical Information

  • Appearance – Semi-solid blue block
  • Biodegradable internal Coconut skeleton
  • Percent Moisture – 12-20% maximum
  • pH 0.5% solution – 5-8
  • Shelf Life – up to 5 years


Each No Chlor Floc Log is designed for placement within a pipe, sewer, or any place that contains turbid water or chlorine contaminated water. No Chlor Floc Log placement is based on gallon per minute flow rates (note: actual GPM or dosage will vary based on site).

Directions for Use

(Mixing of water is very important)

APS No Chlor Floc Logs can be secured inside a closed pipe where the turbid water mixes over and around them. Fins, checks, or other partial obstructions inside the pipe can be used as needed to increase mixing potential. If the pipe system will not be under pressure, holes or access points can be cut into the pipe to facilitate easy loading, monitoring, and replacement of the No Chlor Floc Logs.

High pressure flow and coarse suspended particles will wear down the No Chlor Floc Logs at an accelerated rate. APS No Chlor Floc Logs can easily be moved to different locations as site conditions change. APS No Chlor Floc Logs should be placed in a series, one after another. The number of logs is determined by the flow rate of the water.


Use soap and water to wash hands after handling. Plastic or rubber gloves are recommended for handling after usage.

Precautions / Limitations

  • APS No Chlor Floc Logs will become extremely slippery when wet.
  • Clean up spills quickly. DO NOT use water unless necessary. Extremely slippery conditions will result.
  • APS No Chlor Logs will remain viable for up to 5 years.
  • If performance of this product is not satisfactory, contact Applied Polymer Systems.
Chlorine Treatment
Scroll to Top